EASTMAN ETS-SLS-2, Инструкция по эксплуатации

Страница: 18 / 28

18
®
CAUTION
DO NOT UNDER ANY CIRCUMSTANCES CLICK IGNORE
FAULTS ON A STANDARD PRODUCTION M9000 OR
M9200 MACHINE. THIS COMMAND ALLOWS THE MA-
CHINE TO OPERATE AFTER AN AMP FAULT OR AMP
FAULT MESSAGE OCCURS. THIS SITUATION CAN
CAUSE SERIOUS AND EXPENSIVE DAMAGE TO THE
MACHINE AND WILL VOID THE WARRANTY.
Roll From: selects the direction from which Table Bites on
the marker window are displayed.
The Machine Setting I/O Bits screen.
The I/O bit settings are preset at the factory and should not
be changed. Altering the bit settings will cause improper
functioning of the machine.
WARNING
If the I/O bit settings are tampered with, the emergency
stop switches may not operate.
Start Gripper: Sets the distance from Table Home (X=0.00)
the machine will move to start the gripper. This number will
be negative in order to move the machine backward from
Table Home.
Pull Length: Default pull length used if no cut file is loaded.
Note: if a cut file is loaded, Easicut will automatically calcu-
late how much material to pull based on the table length
(Table Right in the Machine Setting Home screen) and the
length of the patterns in the cut file.
Pull Extra: Accommodates the distance from the end cut-
ter to Table Home. After the material is cut, the machine will
pull the material this specified distance.
Gripper Bit: Address used for the gripper in the computer’s
memory. Do not change this number.
End Cut Bit: End cutter address. Do not change it.
Clamp Bit: Memory address used for the clamp. Don’t
change this number.
Gripper Delay: Time in seconds the machine allows for
the material to be gripped before starting to pull.
End Cut Delay: Time in seconds allowed for the end cutter
to cut the material, after which the machine pulls the Pull
Extra length.
Clamp Delay: Time allowed for the clamp to actuate before
starting the knife.
Pull Velocity: Maximum speed of the machine while pull-
ing.
Pull Accel: Acceleration of the machine while pulling. Speci-
fied in cm/sec/sec, this acceleration rate should be rela-
tively slow.
Edge Buffer: Adds this specified length to the ends of the
pulled material beyond the edges of the cut file. This feature
is helpful to control material movement on the edges.
Label Setting
(Screen Not Shown)
The Machine Setting Label screen.
X-Offset:Sets offset in X direction between laser pointer and
center of label.
Y-Offset: Sets offset in Y direction between laser pointer
and center of label.
The Machine Setting Pull screen.