Earthcore Industries
02/2021
Isokern Maximus Linear Series See-Thru Gas Fireplace
61
Burner Lighting Instructions
INSTALLER INSTRUCTIONS
It is required that the set of safety instruction labels that have been supplied with the appliance be affixed to the
operation and control points of the appliance. It is the installers responsibility to ensure these warnings are properly
affixed during installation. These warning labels are a critical step in informing consumers of safe operation of this
appliance
.
PRE-LIGHTING CHECKLIST
Be sure to check these items before the initial lighting of the appliance:
•
Gas pressure has been checked carefully
•
All gas fittings have been checked for leaks.
•
All clearances to combustibles have been met
•
All combustibles materials have been removed
from the area in front of the appliance.
•
All vented areas of the appliance face are
unobstructed.
•
House is ventilated to clear initial paint curing odors
•
All packaging materials have been removed from
the appliance.
•
While appliance is cool, fingerprints or other marks
have been cleaned from any plated surfaces with
denatured alcohol and a soft cloth. Marks left on
these surfaces may become permanent into the
finish if not removed prior burning the unit.
WARNING!!!:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
SAFETY INSTRUCTIONS
A.
This appliance is equipped with an ignition device which automatically lights the pilot. Do NOT try to light the pilot by
hand.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IFYOU SMELL GAS
:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
C.
If any portion of this appliance does not operate as the instructions indicate, do not try to repair it, call a qualified
service technician. Do not use tools. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to
inspect the appliance and to replace any part of the system and any gas control which has been under water.
Main Power Switch, Battery Holder Switch Pack, and Remote Overview
The ON/OFF switch for ADC100 must be energized to operate the burner system. The battery holder switch pack is
utilized as burner and pilot override switch. When the battery holder switch pack is in
OFF
position, it will not let the
burner or pilot be turned on. When in the
ON
position the burner and pilot will be turned on automatically as soon as
draft is proven. When in the
REMOTE
position, it gives the remote transmitter full control over burner and pilot
functions.
NOTE:
See Remote Control System on pages 62-63 for remote specific operating instructions.
NOTE:
The Remote transmitter will not energize/de-energize the ADC100 control board.
TO TURN OFF GAS TO APPLIANCE
1)
Turn the burner ON/OFF switch for ADC100 to “OFF.”
2)
Turn off all electric power to the appliance if service is to be performed.
3)
Close the main line gas shut-off valve.
WARNING!!!: OPERATION OF THIS APPLIANCE WHEN NOT CONNECTED TO A PROPERLY INSTALLED AND
MAINTAINED VENTING SYSTEM CAN RESULT IN CARBON MONOXIDE (CO) POISONING AND POSSIBLE
DEATH.
