Eagle E-DVR-104, Руководство пользователя

Страница: 52 / 92

User’s Manual
44
Press the button to display the menu screen. The menu on the setup screen has the following
functions:
Turning Zone View On will allow you to observe how the DVR is reacting to motion. When in
the motion viewing mode, any detected motion within the zone will be displayed in red.
You can control excessive event logging and remote notification of motions detected after the
motion dwell time by adjusting the motion ignoring dwell intervals. Highlight the box beside
Motion Ignoring Interval
and press the button. A list of intervals ranging from 1 to 10 seconds
or Never appears. The DVR will not log and notify motion events occurred during the preset
interval range.
NOTE: The record action for motion events will not be affected by the Motion Ignoring
function.
Highlighting Daytime Setup and pressing the button allow you to set up the Daytime range.
Highlight the Actions tab, and the Motion Detection Actions setup screen appears.
The Motion Detection Zone screen is laid over the video
for the selected camera. You can set up motion detection
zones by selecting or clearing blocks.
NOTE: You can set up motion zones one block at a
time in groups of three or six
individual block groups
(4- and 8-channel DVR respectively). A block group
is positioned within the image area using the Up and
Down arrow buttons, and individual blocks within the
block groups are selected or cleared using the camera
buttons.
Select Activates highlighted blocks to detect motion.
Clear
Deactivates highlighted blocks so that they will not detect motion.
Reverse
Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All Activates all blocks to detect motion.
Clear All Deactivates all blocks so that they will not detect motion.
Reverse All
Activates inactive blocks and deactivates active blocks.
OK Accepts changes and closes Zone setup.
Cancel Exits Zone setup without saving changes.
You can adjust the minimum number of detection blocks that must be
activated to trigger a motion alarm. Highlighting the box under the
Min. Blocks
heading and pressing the button allows you to adjust
the minimum number of detection blocks for Daytime and Nighttime
independently. Smaller numbers provide greater sensitivity because
fewer detection blocks must be activated.
Highlight the box beside Daytime and press the button. Use the
Up and Down arrow buttons to set the Daytime range. The DVR will
consider the remaining time range as the Nighttime.