Eagle Healthmate
www.eaglehealthmate.com
10
Assembly Instruction
TOOLS :
1.
Lay the main unit (P1) on even surface.
2.
Take wire (P2) pass it down the middle of the support tube. Please pay
attention to have larger connector at the top. Please see the picture
carefully (P2).
3.
When you assemble the main support tube, make sure the wires remain
connected. Then, connect the bottom connector of wire with in the main
unit. Please see the picture (P3) and make sure the wires remain
connected.
4.
Now, slot the main support tube into the main unit, please see picture P4.
Pay attention to use correct tools and screws: Hexagon screws 8*50. The
picture P5 shows how the main support tube should look like when
connected and assembled.
5.
Take the 2 bottom support bars (P6) and place into the main unit. Please
make sure the top of the bottom support bars are angled away from the
main unit. Take the correct tool and use Middle screws: M6*10 and washers
to secure the bottom support bars to main unit. This should be done at the
bottom of the main unit. See picture P6
6.
Take the top support bars and place on top of the bottom support bars. Pay
attention that the top bars fit into the main support tube. See picture P7
7.
Take the tool and use small screws: 5*10 to secure the top support bars to
the bottom support bars. Please see picture P8.
8.
Use the connect tool and take the big screws: M8*40 and secure the top
support bars to the main support unit. Please see picture P9.
9.
Connect the wires of the control panel to the wires of the main support
tube. Please see picture P10.
10. Place the control panel onto the main support tube and feed the wires
inside the main support. Please see picture P11.
11. Finally, using screws M6*10 at the bottom side of the control panel. Then
use tool to secure the control panel to the main support tube. Make sure to
secure the front screw first, then screw on two sides.
