Eagle Equipment MTP-11V3, Руководство по установке и эксплуатации

Страница: 21 / 43

EAGLE MTP-11V3 Product Manual
21
STEP 10
Installing the Cables
1] Manually raise both carriages to rest on the second set of locks from the floor (Fig. 13).
(Fig. 13)
2] Make sure both carriages are resting on the second set of locks. Carriages must be equal
height from floor.
3] Unwrap both cables. Install 2 nuts on one end of each cable. About an inch (1”) of thread
should show through the nuts. Lock these two nuts tightly against each other. This end will be
inside and at the rear of the carriage after routing.
4] With both carriages in place on the second set of locks, route cables as shown (Fig. 13a &
13b).
(Fig. 13a)