Eagle Equipment MTP-11V3, Руководство по установке и эксплуатации

Страница: 14 / 43

EAGLE MTP-11V3 Product Manual
14
STEP 5 - A
Positioning the Posts for STANDARD Assembly
1] Determine the approach angle for the lift.
Note : It can be helpful to pull a vehicle into the bay prior to installation, to give you a general idea
of where you want to place your posts. Mark and use these locations when chalking more specific
lines.
2] Determine where the power unit will be located. The
POWER SIDE post has the power unit
mounting bracket attached to the side. This post can be positioned on either side.
3] Once location is determined, use a carpenter’s chalk line to lay out a grid for post locations.
(Fig. 5A) Keep all dimensions, and square of the dimensions, within 1/8” or lift malfunction can
occur.
(Fig. 5A)
4] First, snap a center line
down the middle of the bay where the lift will be installed.
5] Next, determine the distance your lift will sit from the back of the bay or door. Twelve (12) feet
minimum are recommended to the center of your lift. Snap a line 135” (or wherever the back edge
of the lift will be set) from the door
.
6] Snap lines 68-1/2” from the center-line on either side of the bay
for a total width of 137”.
7] Raise and position the posts inside the corners of these lines as shown above (Fig. 5A).