EAE EE-6605B.PD, Инструкция по установке, эксплуатации и ремонту

Страница: 16 / 35

Installation, Operation and Parts Manual
EE-6605B.PD
16
5.4 Operation instructions
To avoid personal injury and/or property damage, permit only trained personel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. Always lift the
vehicle using both platforms . Never raise just one end, one corner or one side of vehicle.
Using the lift
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be centered over the lift.
1. Make sure that you have read and understood the operation manual before operation.
2. Drive and park the vehicle midway between two platforms.
3. Turn the selection switch on the control panel to “Main lift ” and push the “UP” button to rasie the lifting platform a little bit off the
ground and check the stability of the lifted vehicle. .
4. Having raised the vehicle to the desired height, operators must push the “Safety Lock” button to ensure the mechanical safety lock is
engaged. Check again the stability before performing maintenance or repair work.
Lower the lift
When lowering the lift pay carefull attention that all personnel and objects are kept clear.
1. Turn on the power switch.
2. Push ”DOWN I” button to lower the lift. It will stop lowering at safety height off the groud.
3. Push “DOWN II” button to continue lowering the platforms. Meanwhile the buzz alarms.