EAE EE-6604BWF, Инструкция по установке, эксплуатации и ремонту

Страница: 19 / 46

Installation, Operation and Parts Manual
EE-6604BWF
- 19
Turn on the power switch
Push UP button
Motor drives the gear pump work
The lift raised
Cylinder piston drives the runway move up
The platforms rise to release
mechanical safety locks
The lift lowered
Push DOWN II when platforms
stop lowering at a safety distance
above ground
Turn on the power switch
Push DOWN I button
5.3 Flow chart for operation
5.4 Operation instructions
The lift must be only used in a static position for lifting and lowering vehi cles. Only use this lift on a surface that is stable and
capable of sustaining the load. Do not install the lift on any asphalt surface.
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing th ese
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift ing platform.
Always lift the vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle.
The normal users are not allowed to open the door of control cabinet. Selection switches in the control cabinet need to be turned to
‘working’ and “infrared on” before using the lift to raise vehicles.
Use the main lift
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be centered over the lift.
1. Drive and park the vehicle midway between two platforms. Make sure the vehicle is correctly positioned and secured against moving.
2. Turn the selection switch on the control panel to “Main Lift”.
3. Push the “UP” button on the control panel to lift the vehicle a bit higher from the ground and check again if the vehicle is in a safe
position.
4. Raise the vehicle to the expected height and push the “Safety Lock” button to ensure the mechanical safety lock is engaged and check
again the stability before performing maintenance or repair work.
Lower the lift
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Push “DOWN I” button to lower the lift. Firstly, the lift will automatically rise to disengage the mechanical locks. It will stop lowering
when the platform lowers to a distance about 600mm off the ground.
Raising Lowering