EAE EE-6604BWF, Инструкция по установке, эксплуатации и ремонту

Страница: 12 / 46

Installation, Operation and Parts Manual
EE-6604BWF
- 12
3.5 Technical data
Rated capacity(kg) 4000
Full raised height (mm) 1900
Full lowered height (mm) 180
Full raised time (with rated load) Approx.60s
Full lowered time (with rated load) Approx. 55s
Hydraulic working pressure ( MPa ) Approx.23
Pneumatic working pressure (Bar) 6-8
Rated capacity of the wheel free jack (kg) 4000
Full raised height of wheel free jack (mm) 450
Oil tank volume (L) 18
INSTALLATION INSTRUCTIONS
4.1 Preparations before installation
4.1.1 Space requirements.
Refer to 3.3 for the dimensions of the lift. There must also be a clearance of at least 1 meter between the lifting platform and fixed
elements (e.g. wall) in all lifting positions. There must be sufficient space at the ends of the lifting platform for driving vehicles on and off.
To stop vehicles colliding with the ceiling, it is advisable to fit an overhead light barrier in low ceiling buildings.
4.1.2 Foundations and connections
The user must have the following work performed before erecting the lift.

Construction of the foundation following consultation with the manufacturer’s customer service or an authorized service agent.
Routing of the wiring to the installation location. The user must provide fuse protection for the connection. Electrical system
connection must be done by licensed technicians. Requirements for power supply cable of the installation site: at least 2.5mm 2 wire
core for 3Ph power and 4.0mm
2
wire core for 1Ph power.

Refer also to the corresponding information on the name plate and in the operation instructions. Before doing electrical connection,
make sure the lift is electrically adapt to the local power supply.

Routing of the compressed air connection to the installation location. The user must install a service unit upstream of the connection.
4.1.3 Foundations preparations
To ensure stability and safety under load, the lift shall be installed with the base frame being in direct and firm contact with the concrete
foundation. Don't attempt to fix the base frame directly onto floor with ceramic and other decorated surfaces otherwise you put the lift
into a very dangerous situation.
Please refer to Annex 1 for floor dimensions.