E-Z-GO RXV GASOLINE, Руководство по обслуживанию и ремонту

Страница: 97 / 190

CONTINUOUSLY VARIABLE TRANSMISSION (CVT)
Page J-3
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions and Warnings.
B
B
Use only sockets designed for use with an
impact wrench. Never use a socket intended
for use with hand tools.
Remove the drive belt (1). (Refer to ‘Removing The
Drive Belt’ procedure elsewhere in this section.)
Remove the Starter/Generator belt (Refer to ‘Starter/
Generator Removal’ in ENGINE section.)
Using a 19mm impact socket with a impact tool and a
impact universal joint, remove the 19 mm bolt (2) from
the center of the drive clutch (5).
Raise the frame with the floor jack so that the power-
train drops and the clutch puller bolt clears the spring
hanger. Remove the front eyebolt from the spring
hanger using a 15 mm socket and a 15 mm wrench.
Install the clutch puller bolt in a clockwise position and
using the impact tool and universal joint remove the
drive clutch from the shaft. Remove the clutch puller
bolt.
In some extreme cases, the clutch may not separate from the
crankshaft. Remove the clutch puller bolt and fill the cavity
with grease. Replace the clutch puller bolt and tighten it with
the impact wrench. The combined mechanical and hydraulic
effect will remove the clutch. Remove all excess grease.
Fig. 3 CVT Components
NOTICE
14
7
6
4
3
2
5
1
11 12
13
14
10
9
8