E-Z-GO RXV GASOLINE, Руководство по обслуживанию и ремонту

Страница: 41 / 190

BODY
Page C-9
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions and Warnings.
B
B
removed the foot rest assembly (29) may be removed
from the vehicle by sliding it backwards and off of the
two remaining bolts.
Fig. 18 Foot Rest Removal
13. Remove four hex head bolts (31) and nuts (32) that
secure the seat back support (33) to the frame, slide
the seat back support up until it clears the rear body.
Fig. 19 Seat Back Support
Installation is in the reverse order of removal.
Replace any worn or damaged hardware with new as
required.
Floorboard
Tool LIst Qty.
Torx Bit, T-50................................................................1
Ratchet ........................................................................1
Insulated Wrench 9/16"................................................1
Torque Wrench, ft. lbs..................................................1
Before the floorboard can be removed the lower and
upper rocker panels, the floor mat, the pedal cover, accel-
erator and brake pedal assemblies, the instrument panel
with trim, the seat back, sweater basket and rear body
must be removed. If the vehicle is equipped with a sun
top and windshield or a 2 + 2 rear facing seat, these must
also be removed.
1. Remove the two Torx screws (44) securing the front
seat support frame (45) to the floorboard (48).
2. Remove two Torx socket head cap screws (46) and
washers (47) that secure the floorboard (48) to the
vehicle frame
Installation is in the reverse order of removal.
Replace any worn or damaged hardware with new as
required.
Fig. 20 Front Seat Support and Floorboard
ITEM TORQUE SPECIFICATION
28 8 - 9 ft. lbs. (10 - 12 Nm)
10 16 - 20 ft. lbs (19 - 24 Nm)
16, 25 15 - 19 ft. lbs (18 - 22 Nm)
22, 30 32 - 36 ft. lbs. (38 - 43 Nm)