ET DC BLUE ADVANCED INSTALLER 2012.025.12.05.2014
3
IMPORTANT WARNINGS TO THE INSTALLER AND GENERAL SAFETY OBLIGATIONS
•
Caution! It is important for personal safety to follow all the instructions carefully. Incorrect installation or misuse
may cause serious personal harm.
•
Keep the instructions in a safe place for future reference.
•
This product was designed and manufactured strictly for the use indicated in this documentation. Any other use
not expressly indicated in this documentation, may damage the product and/or be a source of danger.
•
We accept no responsibility due to improper use or incorrect installation of this product.
•
We will not accept responsibility if the principles of good workmanship are disregarded by the installer. The
construction of the door must be sound and automatable. It is the responsibility of the installer to ensure that all
mountings to the door are sufficient to withstand the necessary forces in cases of overload.
•
It is highly recommended that a set of safety infra-red beams be used in conjunction with this product.
•
Over and above the recommendation to use safety infra-red beams with this product it is mandatory to install
and use a safety beam set when using the automatic closing feature.
•
We accept no responsibility regarding safety and correct operation of the automation if other manufacturer’s
equipment is added to this product.
•
Do not make any modifications or alterations to this product.
•
Anything other than expressly provided for in these instructions is not permitted.
•
Prior to installation:
o
The door must be balanced correctly to the tensioning system. When operated by hand the door
should be free of hindrance and easily moved. When left at any position in its travel, the door should
neither rise nor fall. If the door does rise or fall, re-balance the tensioning system. (Tensioning should only
be carried out by a qualified and experienced person)
o
The door material must be sound and whole. Ensure the areas where the operator attaches have been
re-enforced. The door hardware must be in good serviceable condition.
o
Ensure the wall above the door is sound and strong enough to allow proper fixing of the operator. If
necessary use through bolts and/or cross brace plate to spread the load. (Typically on cinder brick or
hollow walls)
o
The DC Blue Advanced is designed for weatherproof applications only. Install in completely walled and
roofed garages only.
o
Ensure the area of installation is not subject to explosive hazards. There should be no volatile gasses or
fumes as these can present a serious safety hazard.
o
The DC Blue Advanced is designed to be used in low traffic applications only. Do not install on doors
used for multi parking garages like office parks or apartment blocks with a single entrance.
o
The DC Blue Advanced is supplied with a sealed 15A safety plug on lead for use in an electrical code
of practice approved plug point. Do not extend, modify or replace the plug lead unless duly qualified
as an electrician. Before installing the unit, ensure the mains supply is switched off.
o
It is the responsibility of the installer to ascertain that the designated persons (including children)
intended to use the system, do not suffer reduced physical sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning the use
of the system by a person responsible for their safety.
o
The drive may not be installed on a door incorporating a wicket door, unless the drive is disabled by the
release of the wicket door. (Wicket door :- A pedestrian door within the main door)
Cont.…..