Move the whole base part to near the battery,by loosing bottom 4 screws, in order to save more room for
the balance adjustment of camera. Then tighten them.
2
2
1
3
4
Install the PTZ part on tripod with flat base or slider with standard 3/8" screw, then fix it.
1
Assemble(For tripod as example)
1.Please make sure the power is off before finishing installation (power cable is dis-connected).
2.Before locking the plate , please make sure the the plate is inserted in right position, and the
insurance lock is locked.
3.Adjust balance:
(1)Please make sure the camera is fixed tightly.
(2)Please
(3)Please make sure the power cable is dis-connected to battery. Because if only press down
the power button, the motor is still on lock condition and will influence the balance adjustment.
4.If any screw is loosed during installation, please make sure to tighten it finally.
5.Before using, please make sure all locks should be locked tightly.
6.If zoom is used, please make sure the gear of zoom against the focus ring tightly.
7
.
Please choose correct shutter release according to your camera when do time-lapse,stop-motion.
loosen the screws a few turns to allow the tubes to slider. Do not loosen them excessively,
in order to avoid any damage.
Assemble Notes
E-IMAGE MAGIC PTZ Diagram
1
.
PTZ Main Body
1. PTZ part
2. Athenna
3. Tilt motor
4. Power on/off button
5.
6.
Plug holes
Wireless shutter
7. Cable release
8. Focus gear ring
1
3
4
2
15
16
2
.
Wireless Shutter
Wireless Shutter
1
2
3
1
2
3
9
.
10.
11. Quick release plate
V-lock
14.
Power cable
15.
Pan motor
Zoom Cable
Zoom motor
12.15mm/19mm rods
13.
Battery(
not included
)
16. Base locking part
5
Zoom cable
Power cable
Pan motor cable
9
7
8
11
12
13
14
6
10
2016 EIMAGE ALL RIGHTS RESERVED
7
8
2016 EIMAGE ALL RIGHTS RESERVED
