25
E-flite S.E.5a Slow Flyer ARF Assembly Manual
9. Apply light tension on all the rigging at this time. Use
foam-safe CA to glue the end of the rigging in position
once the rigging has been tensioned. Ensure you have
not built a warp into the wings during this process. A
quick sight from the front will verify there are not warps.
10. Using a hobby knife trim, off the remaining thread
once the CA has fully cured.
11. To complete the rigging, follow basically the same
routing, only in reverse. Start by securing the rigging to
the rear lower hole as shown with foam-safe CA.
12. Route the rigging up to the rear of the cabane strut.
