23
E-flite S.E.5a Slow Flyer ARF Assembly Manual
1. Cut an 80-inch (2000mm) piece of the rigging line.
Pass the rigging line through the lower front hole in
the outer strut as shown. Use foam-safe CA to glue the
rigging to the strut, but don't fully cover the hole with CA
as the rigging will eventually pass back through the hole.
Allow the CA to fully cure before proceeding.
2. The rigging will then go through the front hole in the
cabane strut.
3. The rigging will then go between the two cabane
struts.
4. Route the rigging to the front lower hole in the outer
strut as shown..
