42
E-flite Piper Pawnee ARF Assembly Manual
3. Use RC-56 canopy glue to attach the canopy to
the fuselage. Use low-tack tape to hold the canopy in
position until the glue fully cures.
4. Slide a 1/16-inch (1.5mm) drill bit or T-pin through
the hole in the strut mounting block from the inside of the
fuselage to puncture the fuselage covering.
5. Plug the Y-harnesses for the flaps and ailerons into the
receiver. Connect the extensions for the flaps and ailerons
to the Y-harnesses. Label each of the connections so they
can be plugged in later without guessing. Attach the wing
using the two wing bolts and a #2 Phillips screwdriver.
