33
E-flite Piper Pawnee ARF Assembly Manual
9. Use hook and loop tape to install the receiver in the
fuselage following the manufacturer's instructions. A
tube has been installed inside the fuselage to route the
antenna wire.
Do
not
cut the receiver wire if it extends
excessively outside the fuselage as this will greatly reduce
the range of your radio system.
10. Place a clevis retainer onto a nylon clevis, then
thread the clevis onto the rudder pushrod.
11. Remove the backplate from a control horn and attach
the horn to the clevis. Position the clevis in a similar
fashion as the aileron horn and mark the locations for the
two mounting screws.
12. Use a drill and 5/64-inch (2mm) drill bit to drill the
two holes for the mounting screws.
