EN
Carbon-Z Cub SS
6
Model Assembly
(Continued)
Rudder Installation
1. Slide the rudder’s CA hinges (
A
) into the hinge slots (
B
) of the vertical fi n.
2. Install the screw (
C
) in the rudder mount. Do not over tighten, the rudder should
move smoothly.
3. Rest the aircraft on its nose, holding the tail up so the thin CA (cyanoacrylate
adhesive) will fl ow into the slots.
4. Bend the hinges by turning the rudder left, then carefully apply thin CA to each
hinge in the right side of each slot. Repeat this process for the left side of the
rudder. Apply 4-5 drops on each hinge on each side.
5. Connect the ball link (
D
) to the rudder control horn’s middle hole (
E
) using a
screw (
F
) and nut (
G
). Ensure the rudder servo arm is in the correct position,
then adjust the ball link on the linkage to center the rudder.
Required Adhesives:
Thin CA
A
B
D
(
C
) 2.5 x10mm
Button head hex self tapping
Bag D
(
F
) 1.5x10mm
Hex head machine
Bag E
(
G
) 2mm
Lock Nut
Bag C
E
