User Manual EE431
Duct and Immersion Temperature Sensor | 5
WARNING
Non-compliance with the product documentation may cause safety risk for persons (accidents, personal
injury) or damage to property (measurement installation).
▪
Mounting, installation, commissioning, start-up, operation and maintenance of the device may be
performed by qualified staff only. Such staff must be authorized by the operator of the facility to carry out
the mentioned activities.
▪
The qualified staff must have read and understood this user manual and must follow the instructions
contained within.
▪
All process and electrical connections shall be thoroughly checked by authorized staff before putting the
device into operation.
▪
Do not install or start-up a device supposed to be faulty. Make sure that such devices are not accidentally
used by marking them clearly as faulty.
▪
A faulty device may only be investigated and possibly repaired by qualified, trained and authorized staff. A
faulty device shall be removed from the process.
▪
Service operations other than described in this user manual may only be performed by the manufacturer.
1.3 Environmental Aspects
PLEASE NOTE
Products from E+E Elektronik Ges.m.b.H. are developed and manufactured in compliance with all relevant
environmental protection requirements. Please observe local regulations for the disposal of the device.
For disposal, the individual components of the device must be separated according to local recycling
regulations. The electronics shall be disposed of correctly as electronics waste.
2 Scope of Supply
▪
Temperature sensor according to ordering code
▪
Test report according to DIN EN10204-2.2 (for active output only)
▪
Quick guide (digital interface only)
▪
Cable gland
3 Product Description
3.1 General
The EE431 duct and immersion sensor reliably measures the temperature (T) in air and liquids. It is optimized for
building automation, HVAC and process control. The measured data is available at the voltage or current output,
on the RS485 interface with Modbus RTU or BACnet MS/TP protocol and on the optional display. The analogue
output can be set to °C or °F. In addition, the EE431 features a wide choice of sensing elements for passive
temperature measurement.
