21
Operating instructions for EE360 Moisture in Oil
5 operation
5.1
Configuration interface
The.transmitter.can.be.used.for.configuration.or.calibration.via.the.micro.USB.configuration.interface..
An additional supply is not necessary.
After.the.USB.cable.is.connected,.the.transmitter.is.initialised.and.the.configuration.is.loaded..The.
green.status.LED.flashes.and.indicates.proper.operation.of.the.electronics..
Blind cover
USB cable
Fig. 20
Remove the blind cover and plug in the USB cable
PCB
LED 1
LED 2
LED 4
LED 3
Current output
Error LED
error LED on = error category 1
error LED flashes = error category 2
Voltage output
power supply/
main board
Fig. 21
Status LEDs are located at the USB port
5.2 3.5” tFt Colour Display (optional)
The.EE360.display.includes.a.data.logger.and.push.buttons.for.full.configuration.of.the.device..
Upon.start-up.of.an.EE360.with.display,.the.data.logger.and.the.configuration.menu.will.be.initialised.
during.the.first.5.seconds..
1
2
3
4
5
Chart + data logger
Configuration menu
Status information
Buzzer ON / OFF
Error indication / information
5 Display settings
Fig. 22
Display with push buttons
