Page 56 of 146
198-1600-00 Rev F
5)
Selecting “ALL” or an error code from the “Clear Error Menu” will display a
confirmation screen. The top display will show the error code, the bottom display will
show “yES” or “no”. Rotate the current encoder to select “yES” to clear the error
code or “no” to leave the error code active.
6)
When finished viewing and/or clearing error codes select “End” from the “Clear Error
Menu”. Press the voltage encoder switch to exit the “Clear Error menu” and return
to the “Error Handling Setup Menu”.
7)
From the “Error Handling Setup Menu” rotate the current encoder until “Err” “End” is
displayed. Then press the voltage encoder switch to exit
the “Error Handling Setup
Menu” and return to the “Unit Setup Menu”.
8)
From the “Unit Setup Menu” rotate the current encoder until the display shows “SEt”
“End”. Press the voltage encoder switch to exit the “Unit Setup Menu”
6.6. Run Screens
The power supply display is organized into menus and run screens. Run screens provide
information about the supply status, the supply output and other cycle status information. Several
run screens are available providing various sets of information. Run screens are used during
normal supply operation. The SET lamp is off when a run screen is displayed. See
for more details on the overall menu and run screen organization.
Use the following procedure to select which run screen is displayed. The run screen selection is
retained through a power cycle (for example, if the meters were displayed when the unit was
powered off, then the meters will be displayed when the unit powers on). See
for details on the “Display Select Menu”.
1)
Press and hold both encoder switches until the display shows “diSP” “SEL”, then
release them.
2)
The “Display Select Menu” is indicated by showing “diSP” on the top display and the
currently selected run screen on the bottom display. Rotate the current encoder to
select the desired run screen. Then press the voltage encoder switch to exit the
“Display Select Menu” and view the selected run screen. Alternatively the “Display
Select Menu” will automatically exit and display the selected run screen if no
changes are made for several seconds.
6.6.1. Meters Run Screen
The meters run screen is displayed
when “mtr” is selected from the “Display Select Menu”. The
meters run screen shows the voltage meter on the top display and the current meter on the
bottom display. The SET lamp is off when the meters are displayed.
The current or voltage setting can be displayed and changed by pressing the associated encoder
switch. The SET lamp will flash on and off when one or both settings are displayed. When a
setting is displayed the selected digit (blinking) can be adjusted by rotating the associated
encoder. Each press of the associated encoder switch advances the selected digit. When no
