Dynapac F1200C, Руководство по эксплуатации и техническому обслуживанию

Страница: 174 / 296

D 40.12 22
1.4 Starting for paving
Set the switches, levers and controls listed below to the specified positions when the
screed has reached its operating temperature and a sufficient amount of material lies
in front of the screed:
- Press the safety switch (13).
- Then push the drive lever (1)
all the way to the front and start driving.
- Observe the distribution of the material and adjust the limit switches if necessary.
- Set the compacting elements (tamper and/or vibration) according to the required
compaction ratio.
- Let the paving master check the paving thickness after 5–6 meters and correct if
necessary.
Check the area of the caterpillar chains as uneven ground is levelled by the screed.
The caterpillar chains act as reference points for the layer thickness.
The basic setting of the screed must be corrected when the actual layer thickness de-
viates significantly from the values indicated by the scales (see the operating instruc-
tions for the screed).
A
The basic setting is for asphalt material.
Pos. Switch Position
1 Drive lever Centre position
2 Travel drive speed - fast/slow Slow ("tortoise")
3 Travel drive preselector Mark 6-7
4 Engine speed Maximum
5 Screed position Floating position
6 Vibration Auto
7 Tamper (
o
) Auto
8 Auger left/right Auto
9 Conveyor Auto
10 Levelling Auto
11 Speed regulator, tamper(
o
) adapted to the paving situation
12 Speed regulator, vibration adapted to the paving situation