Installation, Operation and Service Manual
LKP Series
5. INSTALLATION
5.1 WARNING
These instructions apply only to retrofit kits installed on standard systems as originally
supplied by Halmar Electronics or DynAmp. Customer is responsible to verify that the units
are standard and do not have non-standard, customer modifications installed. Before
installing the upgrade kit, document any modifications and contact DynAmp, LLC Service
Department for further written instructions to deal with the non-standard circumstances.
The installer is responsible for any damages resulting from improper installation of upgrade kit.
5.2 HANDLING
PRECAUTIONS
Review plant safety regulations, and make sure that personnel involved are aware of the
hazards involved in working with and around high voltages.
The system should be inspected for shipping damage at the earliest opportunity. Visible
damage must be reported to the carrier immediately. Concealed damage (not evident until
the system is operated) must be reported to DynAmp, LLC immediately.
5.3 EQUIPMENT
NEEDED
The following items are included in the LKP-8024 Retrofit Kit
a. 1 each - LKP-8000 High Range Module 1
b. 1 each - LKP-8000 High Range Module 2
c. 1 each - LKP-8024 Installation Parts Kit
Tools Required:
a. Flat blade screwdriver
b. 1 each - Wire strippers
c. 1 each - Digital Multimeter
d. 1 each – OPTIONAL - 1.25 inch hole punch or steel-cutting 1.25 inch hole saw electric
drill and bits
NOTE
The drawings listed in the rear of this manual should be readily available during the
24FM Metering Unit conversion.
5.4 PRELIMINARY
PRECAUTIONS
DynAmp, LLC recommends that all work be done on a de-energized bus. If this is not
possible at your location, shut down the mains power to the 24FM, and observe the
WARNINGS and NOTES that follows.
© 2011 DynAmp, LLC
Page 9
041837 H
