Installation, Operation and Service Manual
LKP Series
TABLE 5.2
FORM FOR RECORDING CHANNEL VOLTAGE MEASUREMENTS
The following table is for the customer's convenience in keeping accurate records on his
unit's performance.
If the channel voltages are measured and recorded at least two hours after the system is
energized has been properly "centered" electrically, the information may prove valuable in
the event of any future malfunction.
It is a good idea to take an additional set of readings at the hottest time of the year,
especially if the equipment is exposed to outdoor temperatures; space is provided for the
recording of three sets of readings. NOTE: Although the channel voltages may vary widely
with temperature extremes, the accuracy will remain unaffected so long as each channel
voltage falls within the limits of +3V to +40Vdc.
Channel voltages are measured between terminals at the Signal converter terminal block
with the LKP meter unit in service on an energized bus.
INSTRUCTIONS
1. Record the channel measurements for every channel (make additional copies of this
form as needed).
2. Supply the information called for below.
CHANNEL VOLTAGES READINGS
FROM
TERMINAL
TO COMMON
TERMINAL
CHANNEL
NUMBER
DATE
____/____/___
_
DATE
____/____/____
DATE
____/____/____
TS1-
VOLTS
VOLTS
VOLTS
27
TS1-35 OR
TS1-36
1
28
“
2
29
“
3
30
“
4
31
“
5
32
“
6
33
“
7
34
“
8
[ ] LOOP BURDEN (TS1 -37 & 38)
[ ] LINE VOLTAGE: (TS1 -52 & 53)
[ ] BUS CURRENT (kA):
Serial Number: ________________________
NOTE: The channel voltages should be b3V and +40Vdc
© 2011 DynAmp, LLC
Page 14
041837 H
