Installation, Operation and Service Manual
LKP Series
Hazard Warning!
All installation, maintenance and service must be performed by qualified
technicians who are familiar with the warnings and instructions of this manual.
The enclosure doors must remain closed at all times during operation to ensure
safety of personnel. A set of keys may be provided for locking the doors. Only
authorized personnel or technicians should open and service the unit.
Disconnect power to the system before servicing or replacing fuses.
Use of the equipment in a manner not specified by the manufacturer can impair
the protection provided within.
DynAmp does not assume liability for the customer’s failure to comply with the
rules and requirements provided in this manual.
GENERAL
This equipment is designed to be connected to hazardous electric voltages.
Ignoring the installation precautions and warnings can result in severe personal
injury or equipment damage.
To avoid the risk of electrical shock or fire, the safety instructions and guidelines
in this manual must be followed. The electrical specifications must not be
exceeded and the unit must be installed according to directions provided.
HAZARDOUS
VOLTAGE
These instructions apply only to retrofit kits installed on standard systems as
originally supplied by Halmar Electronics or DynAmp. Customer is responsible to
verify that the units are standard and do not have non-standard, customer
modifications installed. Before installing the upgrade kit, document any
modifications and contact DynAmp, LLC Service Department for further written
instructions to deal with the non-standard circumstances.
The installer is responsible for any damages resulting from improper installation
of upgrade kit.
This equipment is intended for indoor use only. It should be mounted in a well-
ventilated area, away from high heat, dust, and corrosive atmosphere. The
ambient temperature must not exceed 55
°
C.
For mounting considerations that fall outside the recommended specifications
provided in this manual, the factory should be contacted for approval.
INSTALLATION
Symbol
Identification:
General definitions of safety symbols used on equipment and manual
Caution/Warning: Refer to accompanying documents for instructions.
© 2011 DynAmp, LLC
Page v
041837 H
