No. 60025, Issue 5. January 1999
Programming 8
34
Actuator 1 I Limit
Range:
3 - 12 amps
Default:
6
to
Actuator 5 I Limit
OEM Access: Read / Write
Dealer Access: Read only
Sets the current trip point for each actuator between the allowable range
of 3 - 12 Amps. Refer to the Installation Manual of the Actuator Module
for details.
Actuator Timeout
Range:
1 - 120 sec.
Default:
30
OEM Access: Read / Write
Dealer Access: Read only
Sets the maximum time a wheelchair user can continuously operate any
actuator.
Actr Open Circ Test
State:
yes / no
Default:
no
OEM Access: Read / Write
Dealer Access: Not available
When set to ‘Yes’, an open circuit at the actuator output pins of the
Actuator Module (e.g. TAM or CLAM), will cause a Flash Code 2 to be
displayed (see Diagnostics section). The wheelchair will still drive.
ARC Enable
State:
yes / no
Default:
no
OEM Access: Read / Write
Dealer Access: Read / Write
Must be set to ‘yes’ for Actuator Remote Control (ARC) operation.
Set to ‘no’ for control of actuators by the switches on the Dolphin and
joystick.
Joystick Actuator
State:
yes / no
Default:
yes
OEM Access: Read / Write
Dealer Access: Read / Write
Set to ‘no’ if switch operation of actuators is required. This is not
recommended since the Dolphin has only one switch per actuator.