No. 60025, Issue 5. January 1999
5 Operation
9
Lighting Control
A set of four lighting control switches, with feedback LED's, are provided to
control the Lighting System. A lighting module must be installed and enabled.
Suitable modules include: DX Combined Lighting Actuator Module (CLAM);
a DX Lighting Module (LM); or a DX Servo Lighting Module (SLM).
The Light switch toggles on or off the Head/Tail/Sidelight output,
independently of any other switch (except the On / Off switch). The Light
switch LED is lit when the lights are activated.
The Left or Right Indicator switch flashes the appropriate indicator output.
These are turned off by either pressing the same Indicator switch again, or
pressing the other Indicator switch, or the Hazard switch. Each associated LED
is lit when its matching Indicator switch is active.
The Hazard switch flashes both indicator outputs concurrently. The Hazard
LED also flashes if the Hazard LED is enabled. (See Programming section.)
The Hazard Indication can only be cancelled by pressing the Hazard switch
again.
All lighting functions will only operate with the system power on. Refer to the
relevant Installation Manual (e.g. LM or CLAM) for further lighting details.
Actuator Control
The DX Remote supports the control of up to five actuators if a correctly
configured actuator control module is present (see Programming section). For
example, a Combined Lighting Actuator Module (CLAM) can drive five
actuators or a Two Actuator Module (TAM) can drive two actuators.
The Dolphin has a set of five Actuator Select switches. Pressing an Actuator
Select switch will inhibit driving and select the appropriate actuator output as
indicated by the adjacent LED. The actuator order assigned in the Wizard as
Actuator 1, 2, 3, 4 and 5 Enable, is arranged on the Dolphin keypad as follows: