Dynacord DPM 8016, Руководство по эксплуатации, Страница: 26 / 40

Notice!
Only one PMX-MM-2 can be used in the DPM 8016.
Any of these slots can be used to install the extension cards; once they are installed, they are
automatically recognized by the DPM 8016.
Figure 7.1: Installation of an audio extension card
Network module slot
The network module slot on the rear panel of the DPM 8016 can be used to retrofit an audio
network interface to a CobraNet network. The CM-1 module used here has two Ethernet
connections to set up a redundant network.
Network configuration
The DPM 8016 can be connected to a TCP/IP network via the Ethernet interface on the rear
panel. For information regarding the basics of Ethernet and TCP/IP, see the Appendix, page
35 to this document. The DPM 8016 has the following network configuration by default:
Parameter Value
IP address 192.168.1.100
Subnet mask 255.255.255.0
Gateway 192.168.1.1
DHCP Disabled
Table 7.1: Factory setting for Ethernet interface
An IP address must be unique, i.e., it must only be assigned to one device (host) in a network.
If a new Ethernet is established for operating the DPM 8016, we recommend retaining the
default network ID and subnet mask. When integrating the DPM 8016 into an existing
Ethernet, the network configuration of the DPM 8016 must be adjusted. The default IP
address of the DPM 8016 can be retained if
•
only one single DPM 8016 is connected with the default network configuration via
Ethernet, and
7.2
26 en | Configuration DPM 8016
16-Dec-13 | 02 | F01U259190 Operation manual