Dynacord DPM 8016, Руководство по эксплуатации, Страница: 15 / 40

Installation
The DPM 8016 has been developed for horizontal installation in a conventional 19" rack
cabinet. As a rule, the DPM 8016 must be mounted in such a way that the ventilation slots are
not blocked on either side.
Figure 5.2: Air supply and ventilation of the DPM 8016
The ventilation direction runs from left to right when the device is observed from the front. If
possible, devices with the opposite ventilation feed should not be mounted in the same rack/
cabinet. When installing the device in the housing and rack cabinet, ensure there is a free
channel of air between the sides of the DPM 8016 device and the side walls of the cabinet/
rack up to the level of the upper rack or cabinet vent so that the devices are sufficiently
ventilated. There should be free space of at least 100 mm above the cabinet for ventilation.
!
Warning!
The maximum ambient temperature of +45 °C should not be exceeded.
When installing in a cabinet or transport rack, standard installation rails should be used to
prevent the front panel distorting.
The DPM 8016 must be protected from:
•
Dripping water or spray
• Direct sunlight
• High ambient temperatures or immediate sources of heat
• High humidity
• Large dust deposits
• Strong vibrations
If these requirements cannot be guaranteed, the device must be regularly serviced to prevent
any outages that could occur as a result of negative ambient conditions. If the DPM 8016 is
moved directly from a cold to a hot location, there is a possibility of condensation forming
inside the device. The device must only be commissioned once it has warmed up to the new
temperature (after around one hour). If a solid object or fluid enters the housing, immediately
disconnect the device from the voltage supply, and have it serviced by an authorized call
station before it is recommissioned.
Front bracket
Attach the DPM 8016 on the front side with four screws and washers as shown in the
following figure.
5.3
DPM 8016 Installation | en 15
Operation manual 16-Dec-13 | 02 | F01U259190