MesCom
– Workshop Manual – D6000/i14/V10
© Dycon Ltd 2014
-
16
5.1.5 Transport
If omitted, this is automatically selected based on the address but you may wish to override
the default TCP selection for server /host connections.
0
TCP
1
UDP
2
CSD
3
reserved
4
SMS
5
SMTP
– special case, do not use.
6
APN
– special case, do not use.
7
FTP
– upload a file via FTP.
8
HTTP
– upload events via HTTP PUT or POST methods (for Cosm etc).
5.2 New MesCom (un-administered mode)
The MesCom is supplied in un-administered mode with no contacts pre-configured. In this
mode the MesCom will accept SMS commands from any phone number.
The default
password is the last 4 digits of the IMEI number
. The IMEI is printed on the radio module
inside the MesCom (scanning the quick code will also give you the IMEI) - see picture in
section 3.1.
To exit un-administered mode, you must add at least one contact with administrator level
access. Should you remove all administrators, the MesCom will revert to un-administered
mode.
Once in administered mode the MesCom will only accept commands from users on the
contact list. Should you wish to override this and allow any phone number to access the
MesCom with the default password, see OPTION CMDMODE command.
The first user added when in un-administered mode by default will be added as an
administrator. The default access level for contacts added while in administered mode is the
system default (factory default view <2>).
5.3 Adding a User
The simplest method to add a new user is as follows:
9876 447xxxxxxxxx
This will add the 447xxxxxxxxx as a user with the unit
’s default password. With
read only access unless there are no admin level users subscribed to the device.
9876 ADDNUM
