DX Engineering THUNDERBOLT DXE-MBVA-1UP, Руководство пользователя

Страница: 23 / 32

- 22 -
Feedline Connections
The
DXE-UN-43 UNUN is attached to the feedline using the DXE-TCB-UNFK - UNUN Feed
Point Connection Kit which contains two pre-drilled copper tinned braids for connection to the
vertical antenna system. Both braids are 1" wide by 9" in length. Connect one braid from the
antenna feedpoint located on the base section of the antenna to the terminal on the
DXE-UN-43
UNUN closest to the
Red "+"
on the label as shown in Figure 16 . Do not over tighten the wing
nuts. Hand tighten them only, do not use pliers or other tools to over tighten the wing nuts.
Connect the other 9" braid from the terminal on the
DXE-UN-43 UNUN closest to the
Black
"
▬"
on the label to the closest radial wire bolt on the optional DXE-RADP-3 Radial Plate as
shown in Figure 16 . Route both braided cables as shown.
Note: Ensure the braid connection to the Radial Plate does not interfere with the tilting process.
Figure 16