DX Engineering THUNDERBOLT DXE-MBVA-1UP, Руководство пользователя

Страница: 27 / 32

- 26 -
Guying a Vertical Antenna System
Guying of vertical antennas is always recommended for stability. However, if your area encounters
severe wind velocities or icing conditions, simple guying will reduce the possibility of failure.
Using the
DXE-GUY kits, you can install four guy ropes starting approximately 1/2 the way up the
vertical antenna system to ground level. Guying should be tightened just enough to permit the
antenna to swing a few inches. The ends of the ropes are tied to the earth anchors that are screwed
into the ground at about the same angle as the ropes will be. When using the Tilt Base, position the
guy wires as shown below. This will make it easy to raise or lower the antenna and only one guy
line needs to be loosened. The other guy lines will help guide the antenna on the way up. Depending
on your antenna system, additional guys at points higher on the antenna may be required.
Typical No Slip
Knot for
DXE-SYN-DBR
Double-Braided Dacron DXE-GUY-200
Polyester Rope
Side View
The earth anchors
are approximately
25 feet from the
antenna
Note: Depending on wind and
ice conditions, additional
guying may be necessary.
Top View