DX Engineering THUNDERBOLT DXE-MBVA-1UP, Руководство пользователя

Страница: 9 / 32

- 8 -
Note: The following assembly instructions are based on using a 2" OD Mounting
Pipe, with the optional DXE-RADP-3 Radial Plate.
Radial Plate to Mounting Pipe
Install the optional
DXE-RADP-3 Radial Plate on the 2" customer supplied mounting pipe using an
optional DXE-SSVC-2P Stainless Steel V-Clamp as shown in Figure 1 . The standard 1-1/2"
galvanized water pipe (with its 1.9" OD) is just fine for this application and can usually be found at
your local home building supply store. Mount the Radial Plate so you have approximately 1" of
space between the bottom of the plate and the ground level. This will allow easy access to install
the radial wire hardware. The
DXE-RADP-3 Radial Plate comes with 20 sets of stainless steel
hardware for mounting the radial wires. Mount the plate as shown in relation to how the Tilt Base
is mounted. (For reference,
Figure 7 shows the completed installation.)
Figure - 1 - DXE-RADP-3
Radial Plate Installation