- 6 -
6. Install one 3/4" carriage bolt into the Hot Rodz™ bracket as shown in
Figure 6
using one fender
washer, one split washer and one wing nut. Do not tighten.
Figure 6
7. Install the 12" Hot Rodz™ into the Hot Rodz™ bracket by loosening the wing nut, sliding the
Hot Rodz™ in place in the grooved areas. As shown in
Figure 7
, adjust the Hot Rodz™ so you
have each one extending approximately eight inches on either side. Tighten the wing nut. Do not
over tighten. During the tuning, the Hot Rodz™ will be adjusted equally either inward or
outward.
Figure 7
8. Install the two 2.25" studded band clamps to the stainless steel laser cut 30 Meter AOK
mounting arm as shown in
Figure 8
.
Figure 8
Содержание DXE-8040-30AOK
Страница 3: ...3 Figure 1 Overall Exploded Parts Drawing...
Страница 15: ...15 Notes...
