DX Engineering DXE-8040-30AOK, Руководство пользователя

Страница: 5 / 16

- 5 -
2. To install the four 3/4" carriage bolts into the 30 Meter AOK insulated bracket, use a flat washer
and hex nut. Tighten the nut until the carriage bolt is fully seated on the insulator. Once fully
seated, remove the hex head nut and washer. Install all four carriage bolts from the same side on
the insulator as shown in
Figure 2 .
Figure 2
3. Install the 30 Meter AOK insulated bracket onto the stainless steel laser cut 30 Meter AOK
mounting arm using two flat washers, split washers and hex nuts as shown in Figure 3 .
Figure 3
4. Install the 30 Meter AOK Hot Rodz™ Bracket to the 30 Meter AOK insulated bracket as shown
in Figure 4 using two flat washers, split washers and hex nuts.
Figure 4
5. Install the black plastic end caps on the end of the 12" stainless steel Hot Rodz™ as shown in
Figure 5 .
Figure 5