DX Engineering DXE-8040-30AOK, Руководство пользователя

Страница: 13 / 16

- 13 -
3. Lower the antenna (use a support so the antenna is not laying on the ground) and loosely install
the middle assembly 12-1/2" above the junction of the 2.75" and 2.5" elements as shown in
Figure 18 .
Figure 18
4. Loosely install the upper assembly 10-1/2" below the junction of the 2.25" and 2" elements as
shown in Figure 18 .
5. Run the FLEX-WEAVE™ 30 meter wire attached to the lower assembly through the middle
assembly insulator large hole and attach it to the top bracket using the carriage bolt, flat
washers, star washer, split washer and nut as shown in
Figure 19 .
Figure 19
Final positioning of the upper bracket should be done so the FLEX-WEAVE™ 30
meter wire is parallel to the DXE-8040VA-1. The spring should have tension to allow it
to keep the 30 meter wire taught when the antenna flexes in the wind.
Ensure the lower, middle and upper assemblies are in line and the 30 meter Flex-
Weave wire running between the lower and upper assemblies is snug, but not so tight
that it puts strain on the antenna element.
6. Once positioned properly, tighten the middle and upper assembly element clamps in place.