DX Engineering DXE-7580FS-VA, Руководство пользователя

Страница: 26 / 40

- 25 -
Pivot the antenna base down. This will allow easy assembly of the vertical sections. The further
toward the top you go, you will need to have a support under the sections to keep them straight
while you do the assembly.
Assemble the 3.5" OD element to the 4" OD base element (mounted on Pivot Assembly) using the
two stainless steel 5/16-18 x 5" long bolts, four 5/16” stainless steel flat washers and two 5/16-18
stainless steel Nyloc nuts as shown in
Figure A-2 . When tightening the bolts and Nyloc Nuts,
tighten them enough to hold, but not tight enough to deform the aluminum elements.
Figure A-2 .
Note, you will install the 2.75” x 48” x .120 wall tube
INSIDE the 3” OD section, aligning the
mounting bolt holes then insert these into the 3.5" OD base element. Make sure you insert the 2.75”
OD tube into the correct end of the 3” OD section - the holes at each end are drilled differently.
Align the holes and use two stainless steel 5/16-18 x 4-1/4" long bolts, four 5/16” stainless steel flat
washers and two 5/16-18 stainless steel Nyloc nuts as shown in
Figure A-3 to hold the sections
together. When tightening the bolts and Nyloc Nuts, tighten them enough to hold, but not tight
enough to deform the aluminum elements.
Figure A-3