DVS Atomix LT, Руководство по установке

Страница: 54 / 72

4-2
Atomix LT Installation Guide
Figure 4-1: Setting of Flash controller DIP switch
This setting will load a safe mode programming (fallback map) when
the PCI video board is initialized during start-up. Now use this fallback
map to perform the firmware upgrade once again:

Close the casing of the computer system and plug in its power
cable(s).

Turn on the computer system.

After the start-up of the computer and the loading of the operating
system run the firmware upgrade program (
atomixltup###
, see
section “Upgrading the Firmware” on page 3-15) once again.

When the upgrade program has finished the procedure, shut down
the computer.
You must now set the DIP switch for the Flash controller back to its de-
fault position:

Disconnect the power cable(s) of the computer system.

Open the casing of the computer system.

Then set the DIP switch for the Flash controller back to its default
setting as shown in the respective figure in section “Overview of
the Soldering Side” on page 2-6.

Close the casing and plug in the power cable(s).

Now start the computer.

After the operating system has loaded check the firmware version
as described in section “Determining the Firmware Version” on
page 3-14.
If the firmware version is upgraded, the procedure is finished.
Never operate the PCI video board with the fallback map en-
abled. Make sure that for normal operations the DIP switch is
set back to its default position.