3-9
Installation
3
2
1
I
4
A
Connecting the GPI Panel
A 12-pin flat cable is used to make the connection of the GPI panel to
the board. The connector on the board is located on the rear side of the
expansion module. Set up the connection as shown in the following fig-
ure:
Figure 3-6: Internal connection of the GPI panel
Once all panels are properly connected to the Atomix LT board, you
have to continue the installation with the next step and set up the re-
maining internal connections.
Содержание Atomix LT
