DVS Atomix LT, Руководство по установке

Страница: 32 / 72

2-14
Atomix LT Installation Guide
2.3.4 RS-422 Panel
The RS-422 panel provides two DB-9 connectors for a standard RS-422
connection for remote control.
Pin-outs of the DB-9 connectors can be found in section “Signal In- and
Outputs” on page A-7. The pin-outs of the RS-422 ports can be
switched between master and slave mode in the software.
Figure 2-7: Panel with remote control connections
2.3.5 GPI Panel
The GPI panel is optionally available for Atomix LT 4 BNC and provides
a galvanically isolated GPI based on the opto-isolator technique. It is
available as a low profile panel, i.e. about two-thirds of the height of a
full-size panel. A pin-out of the DB-15 connector provided at the slot
panel can be found in section “Signal In- and Outputs” on page A-7.
Item Explanation
RMT In/Out 1 DB-9 connector (female), serial RS-422 inter-
face for master or slave control
RMT In/Out 2 DB-9 connector (female), serial RS-422 inter-
face for master or slave control
RMT In/Out 2
RMT In/Out 1