DVS Atomix LT, Руководство по установке

Страница: 49 / 72

3-15
Installation
3
2
1
I
4
A

Then compare the version numbers of the output separately with
the numbers stated in the DVS SDK.
If one of the version numbers is lower than the respective numbers stat-
ed in the DVS SDK, the firmware should be upgraded (see section “Up-
grading the Firmware” on page 3-15).
3.4.2 Upgrading the Firmware
In case you determined that a firmware upgrade is required, perform
the following:

Log on to the DVS web site (see section “Required Software” on
page 1-8) and download the required firmware.

Open a command line (shell, or in case of Windows command
prompt (cmd)).

Run the update program
atomixltup###
(
###
is the firmware
version that the Atomix LT board will be upgraded to) and follow
the instructions given on the screen while observing the following:
– During the procedure you will be asked if you want to upgrade
all installed Atomix LT boards in a single step or one board only.
With the latter option selected, the program will loop through
all installed Atomix LT boards and you can decide for each if it
should be upgraded.
– Each board upgrade takes several minutes.
– The program will terminate itself when all upgrades are fin-
ished.

When the upgrade procedure is finished, shut down the computer
and wait at least ten seconds before rebooting it.
This will safely erase the old firmware from the Atomix LT board(s).

Start the computer and, after the operating system has loaded,
check the firmware version as described in section “Determining
the Firmware Version” on page 3-14.
Treat the two version numbers as any version number,
where <a>, as in e.g. <a>.<b>.<c>, has priority over <b>
and both over <c>.
Make sure that the firmware version matches the used DVS
SDK. Notable dependencies will be stated on the DVS web
site and/or in the
readme.txt
and
changelog.txt
of
the DVS SDK.
Only officially released firmware versions are suitable for
end user delivery.