DVG IOM-ITVC-Basic-05, Инструкция по установке, настройке, эксплуатации и обслуживанию

Страница: 41 / 64

ITVC Series – Intelligent Total Valve Controller IOM-ITVC-Basic-05
DVG AUTOMATION S.p.A.
Legal & Operative HQ: 29016 Cortemaggiore (Piacenza) Italy, Via G. Rossetti n° 2
Tel. (+39) 0523 255811; Fax (+39) 0523 255890;
Fully Paid In Capital: Euro 1.000.000,00=
ISO
9001, ISO 14001, OHSAS 18001
CERTIFIED
REA 167410 - VAT 01494460338
COMPANY SUBJECT TO MANAGEMENT AND COORDINATION BY G.I.V.A. S.P.A. WITH HEADQUARTERS IN RHO (MILAN), RECORDED UNDER NUMBER 02917180172 IN
MILAN'S REGISTER OF COMPANIES
info@dvgautomation.it
www.dvgautomation.it
SHEET 41 DI 64
10.3.7.3.3 Firmware version
o
Logic board: Ver 5.1.0 May 2014
o Power board: Ver 4.0.0 June 2014
10.3.7.3.4 ITVC parameter
o List of significant ITVC parameters: stroke duration, stroke delay, next service date, ITVC serial
number, Modbus address, analogue channels, etc.
10.3.7.4 Administrator menu
The following options are available:

Change password

Inverter HPU

Power HPU

Analog inputs

Digital inputs
 Relays
 Modbus 1
 Temperature limits
 Service date
 Max stroke time
 ITVC serial number

Valve

Coil test

Local/Remote cntrl

ESD shutdown

Low bat safety pos
 Operator menu
 MRT
 Pressure eng unit
 Modbus 2
 Battery
 Out analog 1calib

Out analog 2 calib

PSLL/PSHH type

PSLL/PSHH action

Alarm enables

OP after PB action
 Stroke time calibration
 Test coil absorp
 Panic button mode
 Limit switch time
 Reset config
 Calibration L/S
The options in grey are described in this manual IOM-ITVC-Basic. The options: “Power HPU is described in the
ANNEX C, “Low bat safety pos” and “Battery” are described in the ANNEX B, “Limit switch time” is described in the
ANNEX A.
The options “Alarm enables”, “Inverter HPU”,”PSLL/PSHH type” and “PSLL/PSHH action” are reserved for special
application
To return to SETUP page,
by and , position the
cursor on and then
press or press
simultaneously
By and position the cursor
on the desired option and then press
From previous
page of MENU
SETUP
To return to Operator menu page
press or press simultaneously