EN:
1. Locate the Console Mast (9) and slide on Console Mast Cover (82) Make sure the cover is facing
the correct direction, as shown below, before sliding onto mast. Install the wiring harness (94) into
the bottom of the mast and out the top. Be careful when installing the console mast to the
mainframe so as not to pinch or cut the wiring harness; damage to the console may occur.
2. Install the console mast on the mainframe using the 6mm Allen Wrench (103) to tighten 5pcs of
5/16” Socket Head Cap Bolts (102) , 4pcs of 5/16” Flat Washers (44) , 5pcs of 5/16" Split Washers
(46) and 1pcs of 5/16" Curved Washer (45). Snap the Console Mast Cover (82) in place on the
body of the bike.
3. Route the hand pulse wires (96) from the stationary handle bars (10, 11) through Console Mast
(9) as shown below. Use M5 Allen Wrench (68) to tighten 4pcs of 5/16” Button Head Socket Bolts
(43) to secure both handles on the Console Mast (9).
4. Connect the cables (94 & 96) to the Console (58) and install console onto the Mast (9) with 4pcs
of M5 × 12L Phillips head screws (53) by using the Phillips Head Screw Driver (68).
5. Secure Front Stabilizer (12) and Rear Stabilizer (13) with 4pcs of 5/16” Socket Head Cap Bolts
(102), 4pcs of 5/16" Split Washers (46) and 4pcs of 5/16” Flat Washers (44) by using 6mm Allen
Wrench (103).
14
