DURKOPP ADLER 887 Series, Инструкция по эксплуатации, Страница: 43 / 50

7.5 Setting of upper knife angle with regard to bottom cutting edge
Setting of the crossing of the cutting knife (6) and bottom cutting edge
(7) is important for the correct function of the edge trimming and look
of the cut edge of the sewn material. For thinner materials, both cutting
edges should be parallel, with thicker materials, a demand may arise to
slightly turn the front part of the upper knife in the direction of the
bottom knife cutting edge.
–
With a flat Allen key sized 7mm (1) slightly loosen the bolt (2)
located on the bottom of the upper knife holder (3).
–
With a small flat screw (4) turn the setting bolt (5) to achieve the
required holder turning (3).
–
After setting the needed crossing of the cutting edges, tighten the
bolt (2) again.
–
Check the function of the edge trimmer carefully by repeated
lowering of the upper knife, and set the lateral position of the knife
again as needed in accordance with 7.4.
Attention!
By setting of a too large angle of the upper knife in the sewing direction
an increased wear of the cutting edges occurs as well as an increased
load of the edge trimmer electric drive.
41
EN
4
3
5
1
2
6
7