2.6
Position of the eccentric tappet for the switch over of the feed clutch
Rule:
When the handwheel pointer indicates
“313”
on the scale, the dash (1)
on the eccentric tappet should be lined up with the lower dash (2) on
the V-shaped push rod.
–
Loosen screws (3).
–
Turn the handwheel to position “
313
”.
–
Turn the eccentric tappet in the direction of arrow so that dash (1)
is lined up with dash (2).
–
Turn back the eccentric tappet about
2°
and move axially on the
shaft until the middle is between the limit settings.
–
Align the two dashes (1) and (2) again. Tighten the screws (3).
Caution: Risk of injury!
Turn the main switch off.
Only carry out this adjustment when the machine is turned off.
13
EN
3
2
1
Содержание 887 Series
Страница 1: ...887 Service Instructions...
