OPERATING INSTRUCTIONS
DURAMAX BI-TURBO T2
8
DURAMAX OPERATION
After the Power Supply main switch is turned on (fig. a) and the C-run/Reset
Switch is pressed on the power supply,(fig.b) the machine will run a test
sequence for the first 9 seconds. The default program for the DuraMax is floor
only. The program can be changed using the R/C transmitter. (pressing the
Turn Button, then turn the power supply ON and push the C-Run button on the
Power Supply to put the Cleaner in the wall and Floor mode) When the unit is
turned OFF the Power Supply will reset the Unit back to floor only mode.
When the unit is in the
floor and wall mode,
the unit climbs the wall every 4th
time for 15 seconds. Then the machine will search for a wall, it will reverse and
go back towards the wall for 5 seconds, the pump will turn off and perform a turn. After this the pump will turn back on and
will return again towards the wall. The machine will climb the wall for 2 seconds and reverse for 35 seconds and will
reverse again. The machine will repeat this three times. On the fourth time the Cleaner will cross the pool to the opposite
wall and repeat the first three actions moving in the opposite direction
REMOTE CONTROL
When using the Remote Control, fully extend the antenna on the
transformer and aim the Transmitter towards the Power Supply.
Make sure the antenna on the transformer is fully raised for best
performance. Pressing the up and down arrow button will cause the
cleaner to reverse direction and the “Turn” Button will guide your
cleaner either Left or Right depending in what direction unit is
traveling for as long as the button is being pressed.
DURAMAX BI-TURBO T2
has a
delayed start
feature where the machine can
start cleaning the pool an hour after the Main Power Supply is turned on. This is done
by switching the power supply on and pressing the delay button on the remote control.
The UP/DOWN button allows the machine to reverse itself both on the wall and floor. If for any
reason the machine is stuck on the pool floor for more than 6 minutes or if the machine does not
climb a wall within 6 minutes, it will reverse. If the machine climbs out of the water, it reverses itself
every 25 seconds, until water is found. If water is not located within three minutes the cleaner will
shut itself off.
The machine may be programed for
wall and floor or floor only cleaning
. The default mode is set to
floor only
. To change the mode to cleaning floor and wall, press the forward/reverse button on the
remote control once then turn the Main Power Supply switch on and the floor only mode will be
engaged. Turn the Main Power Supply switch on. The machine will first search for the wall. After it
finds the wall, the machine will climb the wall and remain on the wall for two seconds, then it will reverse and head back
down the wall. After the machine reaches the floor, it will move away from the wall for 30 seconds. The 30 second time
should be adjusted from 20-40 seconds so the cleaner has enough time to go slightly past the middle of the pool. The time
may be adjusted by pressing the + or - buttons on the remote control transmitter The + button will increase the time to a
maximum of 40 seconds and “-” decreases to a minimum of 20 seconds. After the time is correctly set. The cleaner will go
from the wall to the center of the pool then reverse, go back towards the wall and climbs the wall for 2 seconds. Each time
DuraMAX
BiTurbo T2
