P7
SPEED
4
8
8
8
8
4
4
12
12
4
4
8
8
4
4
2
P8
SPEED
2
2
6
6
6
8
8
10
10
12
8
6
6
6
4
4
P9
SPEED
2
4
8
10
2
4
8
10
2
4
10
2
4
10
4
2
P10
SPEED
4
6
6
8
8
8
10
10
10
8
8
6
8
6
4
4
P11
SPEED
4
6
6
8
8
8
6
8
6
8
6
10
6
10
8
4
P12
SPEED
4
6
8
10
8
6
4
6
8
12
8
6
8
12
12
6
10、Daily maintenance
Motorized treadmill maintenance
：
Proper maintenance is the key to your treadmill is always at its best, faulty maintenance can damage or shorten
the life of treadmill.
NOTICE:
-Do not use sandpaper or solvent to clean up the treadmill, treadmill controller portion is not directly exposed
to sunlight or moisture, so as not to damage.
-Regular checking and locking all treadmill parts, damaged parts replaced immediately
Adjusting running belt
Adjust the running has two functions: the tension adjustment adjust and run with a central location. Running at
the factory is ready to adjust, but after using the running belt will stretch, friction will cause run off center
location with decorative strips and back cover damaged. In the running belt is stretched is normal.
If you use a running machine, appears to run with a slipping or not smooth, you can adjust the tightness of the
running belt to improve it.
How to adjusting belt
●
6mm hex wrench inserted into the running belt adjusting screw on the left, 1/4 ring turn the wrench
clockwise to adjust the drum to tighten after walking belt.
●
Repeat step 1, adjust the screw on the right side. Must determine the adjustment screws the same distance,
so that the rear drum will adjust relatively parallel to the frame.
●
Repeat steps 1 and 2 until running belt does not slip.
●
Note that the running belt not adjusted too tight. This bad run, additional pressure on the front/rear drum,
roller bearings and other damage, resulting in abnormal noise or other problems.
If you want to reduce the running belt tension please rotate the wrench counterclockwise, attention to the left
and right to rotate the same distance.
Adjusting the belt in the middle
When you use a running machine, because running feet of power is not as big as the pressure imbalance on the
