running belt, resulting in running off center. This deviation is normal, when no one is in operation on the
running belt while running, it will come back to the Center. If not back to the Center, you will need to run back
to the Center.
①.No-load running the treadmill, speed 6km/H.
②.observe the running distance to the left and right side
●
If the left, using the hex wrench, turn the left screw 1/4 clockwise circle
●
If the right, using a hex wrench, turn the right screw clockwise 1/4
●
If the running belt is still not in the Middle, and repeat the action until adjusted to an intermediate
③.After adjusting running belt to the Middle, set the speed to 16km/H, and watch the running belt deviation
and running smooth, if biased, repeat adjustment steps.
④.
WARING！
Do not tighten the drum excessive！This will lead to permanent damage of bearing！
If the above steps do not work, you will need to run and then tighten.
T:tight L:loosen
Lubricant
Treadmill factory-over when the lubricating oil. But check the lubrication of running, which helps keep the
treadmill in the best State. Treadmill in use years or after 100 hours of operation, you must add lubricant.
Every 30 hours of use or after 30 days, from within the side-wing with the start reached encouraged to touch
the running surface, touch silicone oil, you do not need to add oil if you touch the surface when there is a
strong sense of dry, please follow the instructions for lubricating operations.
Use of non-petroleum silicone oil
How to add lubricant：
●
Refueling locations around in the bottom of the product. (see below)
●
Cut the bottle's mouth opened a little, not too large, to be able to inject.
●
Folding treadmill, aim the bottle yellow nozzle, oil injected into the left tube on both
sides even better! Oil finished down product.
●
Boot, wait one minute allowed the oil to spread evenly, then use the treadmill.
T
L
T
L
