Version
1.0
(2016)
Page
5
and follow them during installation carefully.
Any modifications of Durablow remote control system, or parts, or components are PROHIBITED. They will void the
warranty, and may cause a fire hazard result in human casualties and property damages.
Do NOT connect any gas valve or electronic module directly to110-120VAC power.
Read gas appliance manufacturer’s instructions and wiring schematics completely forproper placement ofall
wires.All electronic modules are tobe wired to manufacturer’s specifications.
All wiring diagrams in these instructions are forillustration purpose ONLY.Follow instructions from manufacturers ofgas
valve andelectronic module forcorrect wiring & installation procedures. Improper installation ofelectric components can
cause damage to electronic module, gas valve and remote receiver.
PREINSTALLATION
Decide where to install the receiver box before proceeding.The receiver is designed to be wall-mounted into astandard wall
switch box (STRONGLY SUGGESTED).
Otherwise, you canplace it on or near the fireplace hearth(*IMPORTANT: Keep away from high-heat, exceeding 130°F.
Additional protection required for no exposure to the hearth).
WALLMOUNTING
Make sure the receiver box’s slide switch is in
theOFFposition before installation.
The receiver is connected with 18-inches ofblack wire. If
additional length of wire is required, for the best results, 18
gauge stranded or solid wire are recommended.Splice with
the original black wires ofthe receiver box. Or, remove the
black wires and insertnew wires directly intothe slots at
back of receiver box (Fig, 10).Wires are NOT longer than 20-
feet. Please allow some wire / space toremove the receiver
for battery replacement or check.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
