Version
1.0
(2016)
Page
3
CAUTION:
Due tothe temperature-monitoring components in the transmitter,it isimportant to allow the transmitter todetect
theroom temperature before accurately displaying room temperaturesonthe screen. Normally it takes 5 to 15 minutes
forevery first time placing this transmitter in a new location / environment.
Tobegin the mode cycle (Fig. 3),press and release the MODE button (Fig. 1) until the LCD screen reads OFF (Fig. 4).
Step1
:Press the MODE button one time tomanually turn
ON
the appliance (Fig. 5).Timer
*1
is available in this mode.
The receiver will make sounds of quick BEEP X 2 (
♫
,
♫
).
Step2:
Press the MODE button a second time toput the toput the systemin
THERMO
*2
mode (Fig. 6).
Timer
*1
and Thermostat
*2
are both available in this mode.
★
NOTE: The Thermostat
*2
has first priority to turn OFF when the room temperature reach desired set temperature& it will
turn ON again when the room temperature go below desired set temperature, at the meantime, Timer
*1
keeps countdown.
However, once the set time ends, the Timer
*1
will turn OFF the entire system and go back to OFF mode (Fig. 4).
Step3:
Press the MODE button a third time toturn the appliance back
OFF
again as show in (Fig. 4).The receiver will make
sounds of continuous BEEP for one second (
♫
~~).
Fig. 3
*3
Mode sticker
Fig. 4 OFF mode
Fig. 5 ON mode
Fig. 6 Thermo
*2
mode
Fig. 7
SETTINGUPTHETRANSMITTER
Any blinking numbers on the LCD screen indicate the systemis awaiting user’s input. Using the “
＋
”and “
－
” buttons (Fig. 7)
to increase or decrease the numbers, and press “OK” button to set / confirm. If no change / action is made within 15-seconds,
the system will accept the numbers and finish theprocedure.
SETTINGTHE CLOCK (Fig.7)
1.Press and hold theTIMERbutton on the transmitter for three seconds.The hour digit(s) will become blinking.
2.Press the “
＋
”and “
－
” button to set.
3.Aftersetting the desired hour,press and release theTIMERbutton again tosetthe minutes.
5.Press and hold theTIMERbutton again for three seconds to finish setting. You can also press the OKbutton to finish setting.
CONVERTINGºF/ºC SCALE
